Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Model
Power
LF-40G
3.5 HP
LF-40R
3.5 HP
LF-80G
3.5 HP
LF-90G
3.5 HP
LF-80RM
3.5 HP
LF-90RM
3.5 HP
LF-600G
6.5 HP
LF-650G
6.5 HP
LF-600RM
6.5 HP
LF-650RM
6.5 HP
LF-55C
6.5 HP
Note: The fuel consumption can vary in accordance with the work conditions and gasoline quality, see engine manual.
To get maximum performance, lubricate the wheels
and all points such as pivots with the motor oil every
25 hours.
To lubricate the motor, refer to the "Motor
Instructions Manual".
Keep all nuts and screws tight to make sure the
mower is in usage conditions.
Every time grass is mown, remove all the grass from
the base, both on the top as in bottom of the mower.
Check the cutting blades for
The use of TRAPP original blades.
The correct sharpening of the cutting area and for
optimum balance.
Proper assembly.
Technical Data
Accessories
Motor
Gas.
40
-
Gas.
40
-
Gas.
48
-
Gas.
48
46
Gas.
48
-
Gas.
48
46
Gas.
48
-
Gas.
48
46
Gas.
48
-
Gas.
48
46
Gas.
51
44
Maintenance and Storage
rpm
-
3000
0.8
-
3000
0.8
-
3000
0.8
-
3000
0.8
-
3000
0.8
-
3000
0.8
-
3000
1.7
-
3000
1.7
-
3000
1.7
-
3000
1.7
3000
1.7
Oil change
To make the oil change, proceed as described as
follows, according to the output of each motor.
In lawn mowers with engines of 3.5 HP and 6.5 HP
the oil exchange must be performed by the drain
plug of each engine. After heating the engine, turn
it off and open the engine oil drain plug and tilt
the machine up to the whole oil is drained inside a
vessel, according to the figure.
While performing the exchange of oil, be careful
with the machine hot parts in order to avoid
burnings.
After removing all the used oil, follow the table
above to add new oil in the carter.
Type oil
1
0.45
20W-50
1
0.45
20W-50
1
0.45
20W-50
1
0.45
20W-50
1
0.45
20W-50
1
0.45
20W-50
1
0.6
20W-50
1
0.6
20W-50
1
0.6
20W-50
1
0.6
20W-50
1
0.6
20W-50
47
Tabla de contenido
