Metabo HPT C 3607DRA Manual De Instrucciones página 22

English
Table inserts are installed on the turntable. When
shipping the tool from the factory, the table inserts are
so fi xed that the saw blade does not contact them. The
burr of the bottom surface of the workpiece is remarkably
reduced, if the table insert is fi xed so that the gap
between the side surface of the table insert and the saw
blade will be minimum. Before using the tool, eliminate
this gap in accordance with the following procedure.
(1) Right angle cutting
Loosen the four 5 mm pan head screws securing the
cutting edge plate and with the gap between the left
and right cutting edge plates widened, temporarily
tighten all the 5 mm pan head screws.
Then fi x a workpiece (about 200 mm wide) with the
vise assembly and cut it off . Align the cutting face with
the edge of the cutting edge plate, and tighten all the
5 mm pan head screws.
(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in
Fig. 17-b and Fig. 17-c following the same procedure
for right angle cutting.
CAUTION
After adjusting the table insert for right angle
cutting, the table insert will be cut to some extent
if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust
the table insert for bevel angle cutting.
3. Checking the saw blade lower limit position
Check that the saw blade can be lowered 10 mm to
11 mm below the table insert.
When you replace a saw blade with a new one, adjust
the lower limit position so that the saw blade will not
cut the turntable or complete cutting cannot be done.
To adjust the lower limit position of the saw blade,
follow the procedure (1) indicated below. (Fig. 18)
Furthermore, when changing the position of a 8 mm
depth adjustment bolt that serves as a lower limit
position stopper of the saw blade.
(1) Turn the 8 mm depth adjustment bolt, change the
height where the bolt head and the hinge contacts,
and adjust the lower limit position of the saw blade.
22
2
NOTE
Confi rm that the saw blade is adjusted so that it will
not cut into the turntable.
4. Oblique angle
Before the power tool is shipped from the factory, it is
adjusted for 0°, right angle, left 45° bevel cutting angle
and right 45° bevel cutting angle with the 8 mm set
screw, 6 mm bolt (A) and 6 mm bolt (B).
When changing the adjustment, change the height of
the 8 mm set screw, 6 mm bolt (A), or 6 mm bolt (B) by
turning them.
When changing the bevel angle to the right 45°, pull
the set pin (A) on the direction shown in Fig. 19-b and
incline the motor head to the right.
When adjusting the motor head to 0°, always return the
set pin (A) to its initial position as shown in Fig. 19-a.
8 mm depth
adjustment bolt
Hinge
1
Saw blade
Turntable
Fig. 18