Metabo HPT C 3607DRA Manual De Instrucciones página 28

English
● Always turn the power off and let the saw blade
stop completely before raising the handle from
the workpiece.
If the handle is raised while the saw blade is still
rotating, the cut-off piece may become jammed
against the saw blade causing fragments to
scatter about dangerously.
● Every time one cutting or deep-cutting operation
is fi nished, turn the trigger switch off , and check
that the saw blade has stopped. Then raise the
handle, and return it to the full retract position.
● Be absolutely sure to remove the cut material
from the top of the turntable, and then proceed
to the next step.
● Continued cutting operation can result in
overload of the motor. Touch the motor and if
it's hot, stop your cutting operation at once and
rest for 10 minutes or so, and then restart your
cutting operation.
4. Cutting narrow workpieces (Press cutting) (Fig. 30)
Slide the hinge down to holder (A), then tighten the
slide securing wing bolt (Fig. 3). Lower the handle to
cut the workpiece. Using the power tool this way will
permit cutting of workpieces of up to 58 mm height ×
75 mm width.
1
2
Hinge
28
Slide securing wing bolt
Holder (A)
Handle
Press down
Workpiece
Fig. 30
5. Cutting large workpieces (Fig. 31)
There may be case when a complete cutting cannot
be done depending on the height of workpiece. In
this case, mount an auxiliary board with the 6 mm
fl at head screws and the 6 mm nuts using the 6.5 mm
holes on the fence surface (two holes on each side).
(Fig. 31)
Refer to page 14 "SPECIFICATIONS" for the thickness
of the auxiliary board.
Sub fence (A), (B)
Fence (A), (B)
Width
6 mm nut
Sub fence (A), (B)
Fence (A), (B)
Width
NOTE
When cutting a workpiece exceeding 67 mm in height
in right-angle cutting or 45 mm in left bevel angle
cutting or 22 mm in right bevel angle cutting, adjust
the lower limit position so that the base of the motor
head will not come in contact with the workpiece.
To adjust the lower limit position of the saw blade, follow
the procedure (1) and (2) shown in Fig. 32-a, b.
(1) Tilt the stopper (B) and turn the stopper holder on the
side of the head towards the rear.
Auxiliary board
6 mm flat
head screw
6 mm flat
head screw
Auxiliary board
Fig. 31