Craftsman CMXGPAM1080054 Manual De Instructiones página 15

3. Remove the three hex cap screws holding the chipper chute to the upper
housing. See Figure 19.
4. Remove the front hubcaps, flange lock nuts, front wheels, and wave washers
that attach to the pivot arm assemblies. See Figure 20.
Front Support Brace and Lock Nut
Pivot Arm Assembly
Bell Washer
Thrust Washer
Shoulder Screw
Hub Cap
5. Remove the shoulder screws, thrust washers, and bell washers that go through the pivot arms to the front support brace. The front support brace
and lock nut can be removed at this time as well.
SERVICE AND MAINTENANCE
Figure 19
Wave
Washer
Lock Nut
Wheel
Figure 20
6. Remove the four screws on the upper housing that secure the nozzle cover.
See Figure 21.
7. Carefully tilt and support the unit up to provide access underneath to the
nozzle mounting hardware and impeller. Remove the three shoulder bolts
securing the black plastic lower flail housing to the lower housing. Refer to
Figure 22.
Black
Plastic
Nozzle
Shoulder Screws
8. Tilt top of black plastic lower flail housing toward the engine to remove.
15
Figure 21
Figure 22