Troubleshooting - Samsung POWERbot Manual Del Usuario

troubleshooting

Symptom
the PoWeRbot is not
working at all.
the PoWeRbot
has stopped during
cleaning.
Suction power is weak.
the PoWeRbot cannot
find the docking
station.
the PoWeRbot
suddenly cleans
diagonally.
Point cleaning is not
working.
"Filter inspection
indicator" is on even
after the dustbin has
been emptied.
PoWeRbot does not
clean a certain area.
fCheck if the emergency switch is on.
fCheck if all the icons are displayed on the display panel.
fCheck if the POWERbot's battery is depleted.
- When "Lo" is displayed, carry POWERbot to the docking station to charge it.
fReplace the batteries (AAA type) if the remote control is not working.
fWhen "Lo" is displayed on the display panel, carry POWERbot to the docking
station to charge it.
fWhen POWERbot is immobilized by an obstacle such as a cord, threshold etc,
pick it up and move it away from the obstacle.
- If any fabric or string is caught in a drive wheel, turn off the emergency switch
and remove the fabric or string before using it again.
fIf the "Filter inspection indicator" is on, turn off the emergency switch and clean
the dustbin.
fWhen there's too much dust in the dustbin, suction power may get weakened.
Turn off the emergency switch and empty the dustbin.
fIf the intake (on bottom of POWERbot) is blocked by foreign matter, turn off the
emergency switch and remove foreign matter from the intake.
fWhen noise suddenly increase, turn off the emergency switch and empty the
dustbin.
fCheck if there's a power failure or whether the power plug is unplugged.
fRemove any obstacles around the docking station that may prevent
POWERbot from returning to the docking station.
fWhen there's foreign matter on the charge pins, charging can be affected.
Clean the foreign matter off the pins.
fCheck if the docking station is installed along the grain of wooden floors or
tiles.
fThe POWERbot may clean in a diagonal direction if it is moving to another area
using the shortest route. It may also move at a diagonal if it made contact with
an obstacles at that angle, if it was charged at the docking station at an angle,
or if the grain of the wooden/tile floor skewed is in that direction.
fIf you point the red light directly at POWERbot, it may not move in desired
direction.
- Point the red light on the floor within 4 ft (1 m) of POWERbot.
✻ ✻ Do not use point cleaning in direct sunlight, under bright light, or on dark floors.
fTurn off the emergency switch and then turn it back on.
fEmpty the dustbin again and re-clean the filter thoroughly.
fCheck if the docking station is installed near a narrow passage or door, and
reinstall it in the other areas.
- If the docking station is installed near a narrow passage or door, the
POWERbot cannot pass through the passage or doorsill.
ENGLISH-34
checklist