notes and cautions
Charging
Note
f If the battery overheats during charging, it
may take longer to charge.
f When automatic charging is not working, do
the following:
– Turn the emergency switch (on the bottom of
POWERbot) off and on again.
– Unplug the docking station's power plug and
then plug it back on.
– Unplug the docking station, and then check
whether there is any foreign matter on the
charge pins and clean POWERbot and the
charge pins of the docking station with a dry
cloth or rag.
– Check for any obstacles such as reflective
objects, chairs, etc. near the docking station.
f If POWERbot is left detached from the
docking station, the battery will drain naturally.
– Try to keep POWERbot being charged on
the docking station. (However, turn off the
emergency switch and leave the docking
station unplugged when planning to leave the
house for long periods of time by going on a
business trip or vacation, etc.)
Using
Note
f The POWERbot may get caught on
thresholds, etc. during cleaning.
– To restart operation, shut off the emergency
switch, move the POWERbot to an area where
it can move easily, and then turn on the power
again.
f The POWERbot cannot completely clean
areas it cannot enter, such as corners,
between the wall and sofa, etc.
– Please use another cleaning tool to clean them
regularly.
f The POWERbot cannot vacuum clumps of
dirt, so some may remain on the floor after
cleaning.
– Please use another cleaning tool to clean them
regularly.
f If POWERbot is turned off, you cannot turn
it on by pressing the Power button on the
remote control. Press and hold the [Start/
Stop] button on POWERbot.
f You cannot select and have the POWERbot
execute Spot clean mode while it is charging.
f If you press Manual clean / Point cleaning
button while charging, the POWERbot will be
detached from the docking station and then
turn into the standby mode.
f Do not lie down around the POWERBOT that
is running.
– Your hair may be caught in the Power brush,
resulting in physical injury.
Cleaning and maintenance
Note
f If you washed the dustbin and filter with water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in the shade before
using.
caution
f Watch your fingers when attaching or
detaching the filter, since they may get stuck
in the dustbin's intake.
f To avoid blockages by foreign matter, do not
let the POWERbot vacuum up toothpicks,
cotton swabs etc.
f If it is difficult to remove foreign matter from
the Power brush, contact an authorized
Samsung service center.
ENGLISH-31