To Start The Engine - Husqvarna 226K Manual Del Usuario

CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
10
To fill the fuel tank
1. Clean the area around the fuel tank cap.
Two-stroke oil,
liter
2% (50:1)
2. Shake the container and make sure that the fuel is
0.10
fully mixed.
3. Remove the fuel tank cap and fill the fuel tank.
0.20
4. Tighten the fuel tank cap carefully.
0.30
5. Move the product 3 m/10 ft or more away from the
0.40
refueling area and fuel source before you start the
engine.
US fl. oz.
Note: To see where the fuel tank is on your product,
2 ½
refer to
6 ½

To start the engine

12 ⅞
1. Set the stop switch to the start position.
2. Set the choke control in the choke position.
Product overview on page 2 .
WARNING: Keep the safety distance of 15
m/50 ft when the engine starts. There is a
risk that the harvest attachment starts to
move.
1261 - 001 - 19.09.2019