External Dust Extraction - Skil 3310 Manual De Instrucciones

Integrated Dust Extraction
(see figure C)
For basic dust collection, use the dust bag 21
provided.
– Press the clip of the dust bag
slide the dust bag over the saw dust ejector 24.
The clip must engage into the groove of the
saw dust ejector.
During sawing, the dust bag must never come into
contact with the movable machine parts.
Always empty the dust bag in good time.

External Dust Extraction

For dust extraction, a vacuum hose (size Ø 36
mm) can also be connected to the dust ejector.
– Connect the vacuum hose with the sawdust
ejector 24.
The vacuum cleaner must be suitable for the
material being worked.
When vacuuming dry dust that is especially
detrimental to health or carcinogenic, use a special
vacuum cleaner.
Changing the Tool
(see figures D1–D3)
Before any work on the machine itself, pull
u
the mains plug.
u When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade.
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation
instructions and that are tested and marked in
accordance with EN847-1.
21 together and
45
Removing the Saw Blade
– Bring the power tool into the working position.
1 on the right side and swing back
– Press lever
the retracting blade guard 4 to the stop.
– Hold the retracting blade guard in this position.
– Loosen the screw
screwdriver (Caution:Pre-tension!).
Do not completely unscrew the screw.
– Pull the retracting blade guard all the way
back.
– Turn the Allen screw
27 provided while at the same time pressing
the spindle lock 30 until it engages.
– Hold the spindle lock
the Allen screw 31 in clockwise direction (left-
hand thread!).
– Remove the clamping flange
– Remove the saw blade
Mounting the Saw Blade
If required, clean all parts to be mounted prior to
assembly.
– Place the new saw blade onto the interior
clamping flange 34.
Take care during the mounting that the
cutting direction of the teeth (direction of
the arrow on the saw blade1 agrees with
the direction of the arrow on the retracting
blade guard!
– Place on the clamping flange
screw 31. Press the spindle lock 30 until it
engages and tighten the screw turning in
anticlockwise direction.
– Push the retracting blade guard
the front until Phillips screw 29 engages in the
corresponding recess.
For this, it is possible that you must counterhold
the tool arm by the handle, to achieve the pre-
tension of the retracting blade guard.
– Fasten the retracting blade guard
(tighten screw 29).
–
Slowly guide the retracting blade guard
downward.
29 with the Phillips
31 with the Wrench key
30 pressed and unscrew
32.
33.
32 and the Allen
4 down toward
4 again