Introduction; Safety Instructions; Product Description - Mettler Toledo InPro 5500i Serie Manual De Instrucciones

InPro 5500 i CO
1

Introduction

Thank you for buying this InPro 5500 i Series sensor from
METTLER TOLEDO. The InPro 5500 i Series of sensors are
used for the determination of dissolved carbon dioxide
(CO ) in solutions. They are designed for measuring low to
2
medium levels of turbidity and coloration.
2

Safety instructions

h
Notice: Before every start-up, the sensor must be checked
for:
– Damage to the connections, fastenings, etc.
– Leakage
– Perfect functioning
– A uthorization for use in conjunction with other plant
equipment and resources.
h
Notice: The manufacturer / supplier accepts no responsibility
for any damage caused by unauthorized attachments or for
the incorporation of spare parts which are not of METTLER
TOLEDO provenance. The risk is borne entirely by the
operator.
a
Caution: Before the sensor is put into operation, the
operator must have already clarified that use of the sensor
in conjunction with the other associated equipment and
resources is fully authorized.
a
Caution: A defective sensor may neither be installed nor
put into operation. Faulty containment or installation out of
conformance with regulations and instructions can lead to
the escape of medium or to pressure surges (explosion),
potentially harmful both to persons and to the environment.
a
Caution: The sensor is not equipped with heat protection.
During steam-sterilization procedures in pipes, the surface
of the sensor can reach high temperatures and cause burns.
a
Caution: Some components inside the sensor are energized
with voltages which can cause lethal shocks in case of
contact. The instrument needs to be switched to zero
potential before any operation on the wiring terminal.
a
Warning: Before dismantling the sensor or commencing any
maintenance work on it, ensure that the equipment in which
the sensor is installed is in a safe condition (pressurize, no
explosion risk, empty, rinse, vent, etc.).
3

Product description

The InPro 5500 i is available with three different process
connections for CO
soft drink applications.
– Varivent DN 40
– TriClamp 2"
– 28 mm; M 42
The InPro 5500 i can be used in applications where CIP and
SIP cycles are applied. The sensor has a protective function
where the CO
temperatures (> 55 °C) and turns back on when it cools
down (< 50 °C). This function ensures that the TC-chip will
not be damaged during CIP / SIP.
InPro 5500 i CO
Printed in Switzerland
Sensors
2
measurement in brewery and carbonated
2
-measurement loop shuts off during elevated
2
Sensors
2
© 03 / 16 Mettler-Toledo GmbH
en
15
30 313 397