After Each Use - Craftsman 580.752000 Instrucciones Y Manual Del Propietario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Service Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements
are available at your local
Sears service center.
To service the air cleaner, follow these steps:
1.
Remove screw.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug with recommended
plug if
electrodes are worn or if insulator is cracked or
chipped.
4.
Check electrode gap with wire feeler gauge and
set gap at 0.030 inches (0.76ram), if necessary.
5.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-366-PART.
2.
Carefully remove air cleaner assembly to prevent
debris from falling into carburetor.
AFTER EACH USE
3.
"]'a_e air cleaner assembly apart and clean all
parts. Wash foam air cleaner in liquid de;ergent
and water. Squeeze dry in a clean cloth.
4.
SATURATE foam air cleaner in engine oil and
squeeze in a clean cloth to remove excess oil.
5.
Reins;all clean or new foam air cleaner in body.
6.
Install air cleaner securely on carburetor with
screw.
NOTE: You can purchase now air cleaner elements by
calling 1-800_366-PART.
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump
parts and _freeze" pump action. Follow these
procedures after every use:
1.
Flush detergent siphoning tube by placing filter
into a pail of clean wa;er while running pressure
washer in low pressure mode (adjustable nozzle in
forward position). Flush for one to two minu;es.
2.
Shut off engine and let it cool, then remove all
hoses.
3.
Disconnect spark plug wire from spark plug.
Service
Spark
Plug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
WARNING
Empty pump of all liquids by pulling recoil handle
about 6 times. This should remove most of the
liquid in pump.
If storing for more than 30 days see "Long Term
Storage" on page 15.
14
Tabla de contenido
loading

Tabla de contenido