Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Applying
Detergent
with Adjustable
Nozzle
IMPORTANT:
Use chemicals designed specifically for
pressure washers. Household detergents could
damage the pump.
CAUTION
Pressure
Washer
Rinsing
For Rinsing:
1.
Slide nozzle backward to high pressure, press
trigger and wait for detergent to clear.
NOTE: You can also stop detergent flow by removing
detergent siphoning tube from container.
2.
Keep spray gun a safe distance from area you
plan to spray.
WARNING
To apply detergent, follow these steps:
1.
Review use of adjustable nozzle.
2.
Prepare detergent solution as required by job.
3.
Place filter end of detergent siphoning tube into
detergent container.
,Keep
Sp!ayn_le
b_een 8 t024 inches away from
CAUTION
€leaningtrace
, Operate this unit on a stable surface:
Imlm_mM_llgJm
_'{'dil"_[ttlim m
_r_
Ira
/
lIE IIEaiI /
, Be extremely careful is you must use the pressure
washer from a !adderi scaffo!djng or any other relatively
', When inserting the fi!ter into a detergent solution bottle,
.... Unstableiocatien........................................................
route the tube s0 as t0 keep it fr0m inadvertently
............ ......
c0nta_ing _e hot raUffler.
Firrn!y graS#SpraygunWith b°th hands when us!nghigh
pressure spray to ayoid injury if gun kicks back.
4.
Slide adjustable nozzle forward to low pressure
3.
Apply a high pressure spray to a small area, then
check surface for damage. If no damage is found,
it is okay to continue cleaning.
Start at top of area to be rinsed, working down
with same overlapping strokes as you used for
washing and applying detergent.
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125=F. The system engages to
cool the pump by discharging the warm water onto
the ground.
mode. Detergent cannot be applied with nozzle in
high pressure position.
5.
MaKe sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump. Start engine.
6.
Apply detergent to a dry surface, starting from
bottom and working up.
7.
Allow detergent to =soak in" for 3-5 minutes before
rinsing. Reapply as needed to prevent surface
from drying.
8.
For washing, start at lower portion of area to be
washed and work upward, using long, even,
overlapping strokes.
IMPORTANT:
You must flush the chemical injection
system after each use by placing the filter into a clean
bucket of water and running the pressure washer in
low pressure for 1-2 minutes.
10
Tabla de contenido
