Craftsman 580.752000 Instrucciones Y Manual Del Propietario página 9

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

How
to
Stop
Your
Pressure
Washer
1.
Move throttle lover to "Stop" position.
2.
Squeeze trigger on spray gun to relieve
pressure in hose,
NOTE: A small amount of water will squirt out when
you release the pressure.
3.
Rotating nozzle adjusts spray pattern from a
narrow pattern to a fan pattern.
How To Use the Adjustable
Nozzle
You now should Know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
CAUTION
• NEVER adjustspray pattern when spraying.
• NEVERput handsin front of nozzle toadjust spray p_tern
On the end of your spray gun is a nozzle handle that
can adjust the spray pressure and the spray pa_ern.
1.
Point nozzle toward ground, disengage safety
latch, and press trigger to l:est pa_ern.
2.
Sliding nozzle forward and bacK adjusts spray
pressure.
Twist no>71e counter-
Twist nozzle ¢!o¢_ise
for
clockwise
for fan Pattern
narrow spray pattern,
4.
For most effective cleaning, Keep spray nozzle
between 8 to 24 inches away from cleaning
surface.
5.
If you get spray nozzle too close, especially using
high pressure mode, you may damage the surface
being cleaned.
6.
DO NOT get closer than 6 inches when cleaning
tires.
Using
the Turbo
Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. The high pressure spray is most
effective when the tip of the nozzle extension is held
between 8 to 24 inches from the surface being cleaned.
CAUTION
hiddenarea.
To attach the turbo nozzle to the spray gun:
1,
Engage safety latch to spray gun trigger,
2.
Remove the nozzle extension from the spray gun,
if attached.
3.
Attach the turbo nozzle extension to spray gun.
_.
Disengage
safety latch to spray gun trigger.
5.
Always start the turbo nozzle at a disl:anca,
Siide nozzie backward
Slide nozzle f0P,_vatd for I_
gradually getting closer to the surface until you get
high pressurem0dei
p_essure mode and
the cleaning force you want.
detergent app!i_tion.
NOTE: Detergent cannot be applied with turbo nozzle.
9
Tabla de contenido
loading

Tabla de contenido