Conformity And Approval; Safety Notes - Monacor TXA-900DCD Manual De Instrucciones

TR 03
B
2
MIC / LINE
INPUT
1
MIC / LINE
INPUT
6
Portable Amplifier System
These instructions are intended for users without
any specific technical knowledge . Please read the
instructions carefully prior to operation and keep
them for later reference .
1 Applications
This active speaker system combines a 2-way
speaker system, an amplifier with two input
channels, a CD / MP3 player and a receiver for
a wireless microphone (hand-held microphone
with transmitter or pocket transmitter with micro-
phone ☞ chapter 1 .1) . The two input channels
will allow connection of both microphones and
audio units with line level (e . g . mixer) .
The unit is specially designed for mains-inde-
pendent operation . For power supply, a battery
is integrated which will be recharged with the
internal charger . Thus, the unit is ideally suited
for mobile PA applications at events, lectures, etc .
To provide PA application of larger areas, it will
be possible to interconnect two TXA-900DCD
systems .
1.1 Suitable wireless microphones
The following models are available:
Model Type
Hand-held microphone with
TXS-821HT
integrated transmitter
Pocket transmitter with
TXS-820LT
tie clip microphone
Pocket transmitter with
TXS-820SX
headband microphone
Pocket transmitter for
TXS-820HSE
a headband microphone e. g. HSE-110

1.2 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the receiver of the unit TXA-900DCD com-
plies with the directive 2014 / 53 / EU . The EU dec-
laration of conformity is available on the Internet:
www .monacor .com
The wireless system (receiver and corresponding
transmitter) is generally approved for operation
in EU and EFTA countries; it is licence-free and
requires no registration.
A
DISC
03:19 CDA
D
C
SD/SDHC CARD
FUNC
HIGH
VOLUME
RF 3
MID
4
LOW
4
BASS
BOOST
VOLUME
8
RF
7
MIX OUT POW IN
(MASTER) (SLAVE)
0 dB

2 Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water, high
air humidity and heat (admissible ambient tem-
perature range 0 – 40 °C) .
•
Do not place any vessel filled with liquid on the
unit, e . g . a drinking glass .
•
Do not operate the unit and immediately dis-
connect the mains plug from the socket
1 . if the unit or the mains cable is visibly dam-
aged,
2 . if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the unit must be repaired by skilled
personnel .
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated, or if it is
not repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .
MUTE
M-32CD
REMAIN
FOLDER REPEAT PROG
CD
MUTE
VOLUME
4
E F
CD
G
CD
ON
5
11
LIMITER
10
AMP ON
AMP ON
9
12
CHARGE
> 75 %
13
25 ~ 75 %
< 25 %
MONACOR INTERNATIONAL·ZUM FALSCH 36·28307 BREMEN·GERMANY
.
voltage . Leave servicing to skilled
personnel . Inexpert handling may
result in electric shock .
14
15
3 Overview
1 Mono input for channel 1 for connecting
a microphone via an XLR plug or an audio
source with line signal level* via a 6 .3 mm
plug
Note: If a wireless microphone is used, it will re-
serve channel 1 .
2 Reception LED RF: will light up when a radio
signal is received
3 Volume control for channel 1
4 Equalizer for both channels 1 and 2
LOW, MID, HIGH
5 Button BASS BOOST for boosting the level in
the bass range (LED will light up when the
function is activated)
6 Mono input for channel 2 for connecting
a microphone via an XLR plug or an audio
source with line signal level* via a 6 .3 mm
plug
7 Volume control for channel 2
8 Output jack MIX OUT (MASTER) and input
jack POW IN (SLAVE) for connecting two
active speaker systems TXA-900DCD
☞ chapter 6 .2
9 Power switch AMP ON of the active speaker
system
Note: The internal charger will always be in opera-
tion when the unit is connected to a mains socket,
even when the unit is switched off .
10 Power LED AMP ON of the active speaker
system: will light up when the unit is
switched on
11 LED LIMITER: will light up when the input level
of the amplifier is too high and is limited by
the integrated limiter
12 CHARGE LED
red: battery charge in process
green: battery charge completed
13 LEDs for the battery charge status
If the red LED lights up, the battery should
be recharged .
14 Mains jack for connection to a socket (230 V/
50 Hz) via the mains cable provided
15 Support for the mains fuse;
always replace a blown fuse by one of the
same type
* e. g. mixer, CD / MP3 player, tape deck, tuner
7