Display Symbols; Functions - Adam Equipment AELP Serie Manual De Usuario

5.2

DISPLAY SYMBOLS

Symbol
ZERO
STAB
PCS
kg or g or t
BAT-LO
TARE
- Lo -

6.0 FUNCTIONS

• To change functions press the [Func] key.
• The functions that are available can be cycled through by
pressing [Func] key.
• Not all functions may be enabled. Some functions may be set
during the initial configuration and the user is not given access to
them. In this case those will not be seen when the [Func] key is
pressed.
• To use any of the functions see the corresponding section of the
manual.
• If you continue to press the [Func] key you will eventually be
returned to weighing.
Function
1.
AVE
2.
bod
3.
FIL
4.
cont
5.
PIECE*
6.
© Adam Equipment Company 2005
Scale in auto zero range (indication = accurate zero)
Result is stable
Scale in parts counting mode
Scale in weighing mode
Batteries are weak, after 5 minutes the scale will turn off
Scale has been tared
When weight is above the High setpoint
When weight is between the setpoints
When weight is below the Low setpoint
During parts counting sample size is too small
F u n c t i o n s A v a i l a b l e
bL
Enables / disables the backlight (if used)
Changes averaging of weighing result
Changes baud rate for RS-232 transmission speed
Changes ADC filtering
Enables or disables continuous printing
Enters parts counting
Description
Description
7