Supp = Power Supply Voltage To Pcb; Communication With A Computer/Printer; Parameter; Connection - Adam Equipment AELP Serie Manual De Usuario

6.15 SuPP = Power supply voltage to PCB

• To set the parameter press the [Func] key to show "SuPP".
• Press [Print] to see the parameter.
• The display will show the current voltage to the PCB.
• Press any key to return to normal weighing.

7.0 COMMUNICATION WITH A COMPUTER/PRINTER

The following applies only to scales supplied with an RS-232 interface.
• Press the [Print] key to transmit weighing data (value and unit of
mass) to a computer or printer.
• The AE 106 indicator can be connected to a printer for printing
the results of the weighing or to a computer to either display or
control the balance through the RS-232 interface. The commands
can tare the balance or request the weight be printed.
7.1

PARAMETER

The interface parameters are:
300 - 9600 Baud as selected, see section 2.3, default 4800 baud
8 data bit
No parity
1 stop bit
7.2

CONNECTION

Depending upon case style the output is either using a 9 pin D-subminiature
connector or a 6 pin Audio Connector.
If the output connector is a 9 pin D-subminiature plug. The output pins are:
Pin 2 Input
Pin 3 Output
Pin 5 Signal Ground
It is necessary to jumper pin 7 to pin 8 to enable the RS-232 interface
circuits. Do not connect these pins to the handshaking pins on the interfaced
device.
© Adam Equipment Company 2005
16