Warranty Term - TRAPP Master 500L Manual De Instrucciones

Metalúrgica TRAPP guarantees the quality of this
product for the period of 12 (twelve) months,
counting from the date that the Purchase
Document is issued to the Consumer.
The Total Warranty of 12 months covers defects
of manufacturing, materials and the respective
labor for the repair, after the due confirmation
by the technicians of TRAPP or accredited
technical assistant, by means of a report.
Notes:
•
All the parts proved to be defective, within
the warranty period, will be replaced,
without charge. Under no circumstances will
it be possible to exchange the appliance or
equipment.
•
This Warranty cannot be transferred and will
only be valid upon presentation of the
Purchase Document.
•
This product may have modifications of
technical specifications and design without
prior notice by the manufacturer.
The Warranty covers the following
manufacturing defects:
•
Short of coils;
•
Short between phases;
•
Failed rotor;
The Warranty does not cover:
•
The expenses arising from packaging and
transport of the product to the TRAPP
Authorized Technical Assistance;
•
The replacement of parts damaged in
transportation;
•
Loss of parts.
This Warranty will have complete loss of
validity in any of the following cases:
•
Broken shaft;
•
Parts broken or crushed;
•
If the product is opened by a company not
30

Warranty Term

•
Assembly error;
•
Failure of material.
authorized by TRAPP;
•
Exposure of the equipment to humidity,
water, bad weather, sea air, chemical
products, etc.
•
Parts which have normal wear from use;
•
Defects caused by undue use, ignorance
and non-execution of the instructions
contained in the Instruction Manual, undue
use being;
•
Use of the product without the protection
skirt;
•
If the product is not used only for finishing
in gardens, and the edges of flowerbeds,
sidewalks, walls and other obstacles, in the
case of the model Master 500L;
•
If this product is connected to a voltage
differing from the one specified for the
equipment;
•
Surge;
•
Use of an electric extension lead other than
the one specified in the Instruction Manual;
•
Use of nylon thread outside the
recommended diameter;
•
If the product is not used for cutting grass in
areas of up to 50 m , for the models Master
2
700L, Master 800 Plus, Master 1000 Plus,
Master 800 and Master 1000L.
ATTENTION!
USE
TRAPP ORIGINAL PARTS
and profissional services of TRAPP
Technical Autorized Assistance.
TRAPP does not undertake responsability
for eventual damages caused to the
equipment, neither for accidents that may
occur due to use of non-original parts.