Connecting Players (Turntable Connection); Connecting With Onkyo Ri Components - Onkyo A-9110 Manual De Instrucciones

Connecting players (Turntable
connection)
a Analog Audio Cable
a
Use an analog audio cable to connect a turntable that uses
an MM-type cartridge to the PHONO jack.
If the turntable has a ground wire, connect it to the GND
terminal. With some turntables, connecting the ground wire
may cause hum, in which case it should be disconnected.
0 If the turntable has a built-in audio equalizer, connect it to
an LINE IN jack other than the PHONO jack. Also, if the
turntable uses an MC type cartridge, install an audio
equalizer compatible with the MC type cartridge between
the unit and the turntable, then connect to any LINE IN
jack other than the PHONO jack.
Connecting with Onkyo RI
Components
a RI Cable, b Analog audio cable
Turntable
If you have an Onkyo CD player, tuner, network audio
player, or RI dock, if these have RI jacks, then you can
connect them to this unit and link switching between on and
standby, and use the remote controller of this unit to
centrally control the equipment. (RI function)
These linked operations are enabled by the connection with
an RI cable between the equipment with an RI jack and this
unit, and the connection using an Analog audio cable. Refer
to the following table for connections.
Equipment connected
CD player
Tuner
Network audio player / RI
dock
The RI function
The follow system functions can be used with the RI
function.
0 Some functions may not be supported depending on the
product even when an RI connection is used.
∫ Auto Power On
When this unit is in standby mode, if a component
connected by an RI cable is turned on, this unit
automatically turns on.
Preparations
b
Jack to connect to
LINE IN 1
LINE IN 2
LINE IN 3
a
CD
11
En