Rear Panel; Speaker Setup - Phonic POWERPOD 740 PLUS Manual Del Usuario

Rear Panel

11. Speaker Outputs
These jacks are used to connect to speakers, fed from the internal
power amp. On all models, they consist of 1/4" phone jacks. The
amp Select switch determines the operation of these jacks. If the
amp Select switch is set to "Main 1 / Main 2" or "Main / Moni", a
single speaker with a 4 to 8 ohm load can be connected to jack
a on both the Main 1 and Main 2 Speaker Outputs. You can also
connect two speakers with impedances between 8 and 16 ohms
to both jacks a and B of the Main 1 and Main 2 Speaker Outputs.
When using Bridge Mono mode, use the Speaker Output labeled
"Bridge" only to connect a Speaker with a loading between 8 and
16 ohms. Refer to the Speaker set up chart to the right for a more
detailed indication of how to connect speakers.
NB. Due to the fact that the signal has been processed by the power amp,
these ports should be used in conjunction with passive speakers only to
avoid damaging any other equipment.
11
Please note that the Bridge Mono function is only available on
the Powerpod 740 models, and is not available on the Powerpod
780 models. With this in mind, we ask customers that own these
models to ignore the Bridge connection found in the following
speaker setup diagrams.
4
POWERPOD 740 PLUS / 740R / 740FR / 740W / 740RW / 780 PLUS
SPE A K ER SETUP
Not used
Using speakers with an incorrect loading can not only cause
distortion, but also irreversible damage to the powered mixer.
Please ensure the loadings of your speakers are consistent
with those shown above.
Not used
Not used
Not used