Rear Panel Descriptions - Phonic ZX2 PLUS V1 Manual Del Usuario

REAR PANEL DESCRIPTION
14 15 16
14. Power Cable Receptacle
This is a standard IEC power cable receptacle. Plug the power
cable in here and connect the other end of the cable to an
appropriate AC mains power supply.
15. 24VDC Control
This terminal black input accepts an external 24 VDC regardless
of the position of the positive and negative poles. It will activate
the emergency function, which will route the external emergency
message to all zone and utility outputs. It provides an override
control for emergency use.
16. Audio Input
This 3-pin phoenix/euroblock input jack accepts input by
balanced or unbalanced connections. This input works in
conjunction with the 24V DC CONTROL. When the circuit is
activated by a 24V DC power supply all other audio input
sources will be terminated and whichever audio source is
connected to the emergency audio will be routed to all zone and
utility outputs. The grounding and positive and negative
connections should be wired as indicated by the G, + and - text
on the connector.
17. Utility Output
This is a standard line-level 3-pin phoenix/euroblock output for
balanced or unbalanced connections. The grounding and
positive and negative connections should be wired as indicated
by the G, + and - text on the connector.
ZX2 ZX2 / ZX4 / ZX4
PLUS V1 PLUS V1 PLUS V1 PLUS V1
17 18
18. Zone Outputs
These are standard 3-pin phoenix/euroblock connectors. The
zone outputs include left (L) and right (R) channel outputs (zone
4 on the ZX4 only has a mono output channel). There is also a
subwoofer (SUB) output included for better low frequency
performance (ZX2 only). When operating in mono mode, use the
left channel's connector only.
19. Remote Level Control
This socket allows for the connection of external volume control
devices to remotely control music. Each remote socket controls
up to two zones. When the REMOTE connection is not made, the
output level of each zone will be according to the level selected
on the mixer. Please use a 10k ohm potentiometer as the remote
level controller.
19 18
18 19 18
ZX2
ZX4