Tabla de contenido
Idiomas disponibles
Idiomas disponibles
60. Main Outputs
These outputs will output the final stereo line level signal sent
from the main mixing bus. The primary purpose of the two XLR
jacks is to send the main output to external devices, which may
include power amplifiers (and in-turn, a pair of speakers), other
mixers, as well as a wide range of other possible signal processors
(equalizers, crossovers, etcetera). The two 1/4" phone jacks
are able to send the Main output to external devices that may
run in parallel with the mixer. This may include additional power
amplifiers, mixers, PA systems, as well as a wide range of other
possible signal processors.
61. Main Insert Point
Like the Insert Points on input channels, the primary use for these
TRS phone jacks is for the addition of external devices, such as
dynamic processors or equalizers, to the Main L and R mix. This
will require a Y cord that can send (pre-fader) and receive signals
to and from an external processor. When the main insert is in use, it
will affect the signal sent to both the 1/4" and XLR main outputs.
61
AM2442FX / AM3242FX
Rear Panel
62. Phantom Power
When this switch is in the on position, it activates +48V of phantom
power for all microphone inputs, allowing condenser microphones
(well, the ones that don't use batteries) to be used on these
channels. Activating Phantom Power will be accompanied by an
illuminated LED above the left channel Level Meter. Before turning
Phantom Power on, turn all level controls to a minimum to avoid
the possibility of a ghastly popping sound from the speakers.
NB. Phantom Power should be used in conjunction with balanced
microphones. When Phantom Power is engaged, single ended (unbalanced)
microphones and instruments should not be used on the Mic inputs.
Phantom Power will not cause damage to most dynamic microphones,
however if unsure, the microphone's user manual should be consulted.
63. Power Switch
You can use it to turn the mixer on and off. Ensure you turn all
level controls down before activating.
64. Power Connector
Used for the addition of a power cable and supply, allowing power
to be supplied to the mixer. Please use the power cable that is
included with this mixer only. The Fuse holder, located above
the AC Power connector, is, of course, for the AM mixer's fuse.
If the fuse happens to blow, open the holder cover, and replace
the fuse with a suitable replacement (as indicated on the fuse
holder's cover).
60
62
64
63
7
Capítulos
Tabla de contenido
