Input Power Connections - ESAB CC-11 Manual De Instrucciones

SECTION 3 INSTALLATION
3.1

Input Power Connections

A 3­conductor power cable suitable to meet the required input power must be installed . The cable must have
0 .25" (6 . 4 mm) ring lugs installed on the machine end . Connect the power leads to the L1 and L2 terminals on
TB1 Input Power Terminal Board and the ground lead to the ground lug on the back of the fan support panel . A
strain relief fitting is provided to feed a power cable through the rear panel of the cabinet . Refer to Figure 3 .2
for proper Input Voltage Link placement, Figure 3 .2 shows link in place for 460 volt input . Electrical installation
must be in accordance with local electrical codes for this type of equipment .
Figure 3.2 Voltage Links
62