CEA DIGISTAR 250 DUAL PULSED Manual De Instrucciones página 29

The 5 welding methods are indicated, when the LEDs are active,
in the following manner:
Selected welding method: 2T
Selected welding method: 4T
Selected welding method: 2T CRATER
Selected welding method: 4T CRATER
Selected welding method: SPOT WELDING
ENCODER 1 Led
Shows that the value of the parameters displayed on the A -
PARAMETERS Display can be changed by turning the ENCODER
1 knob.
ENCODER 2 Led
Shows that the value of the parameters displayed on the V -
PARAMETER DISPLAY can be changed by turning the ENCODER
2 knob.
HOLD FUNCTION Led
Shows that values of parameters displayed by the A and V - PA-
RAMETERS Displays are respectively the current and voltage
values at the end of the last welding. The led flashes for 15 sec-
onds or until you press any currently activated key.
A - PARAMETERS Display
This display reads the following functions (if activated):
• WELDING CURRENT both pre-set (in SYNERGIC mode only)
and actual;
• WIRE SPEED both pre-set and actual;
• THICKNESS OF ITEM BEING WELDED pre-set (in SYNERGIC
mode only).
V - PARAMETERS Display
This display reads the following functions (if activated):
• WELDING VOLTAGE both pre-set (in SYNERGIC mode only)
and actual;
• TRIMMING ADJUSTMENT OF WELDING VOLTAGE (in SYN-
ERGIC mode only);
• ELECTRONIC INDUCTANCE
Programme DISPLAY
This display shows:
• The number of the programme when the wording P + a num-
ber varying between 000 to 299 appears;
• The work setting (spot) number when the wording Au + a num-
ber varying between 01 and 99 appears.
The setting is active if the numbers after the wording remain un-
altered, flashing settings are not active but can only be memo-
rized.
29