Orbegozo REH 500 A Manual De Instrucciones página 29

REH 500 A 1000 A 1500 A 2000 A
How to mount the heater
1. After selecting the location to install the thermal emitter, place an upper support vertically on the
wall and mark the two holes with a spacing of 30 mm. Once done, and depending on its thermal
emitter, choose the distance D1 with respect to the previous signals (Fig 3)
2. Make four holes, insert wall plugs and screw the upper brackets to the wall (Fig 4)
3. Screw the bottom to the bottom of the emitter.
4. Hang the thermal emitter and mark the point to be drilled bottom bracket (Fig 5).
5. Lift the transmitter and make the hole.
6. Hang transmitter again and screw the bottom bracket to the wall so that the sender is completely
fixed (Fig 6
Screw wall
wall
Hang up
29