Causes of damage
NOTICES:
Risk of damage due to corrosion. Always turn
▯
appliance on when cooking to avoid condensation
buildup. Condensation can lead to corrosion
damages.
Always replace defective bulbs immediately to avoid
▯
an overload of the remaining bulbs.
Risk of damage due to ingress of humidity into the
▯
electronic circuitry. Never clean operator controls with
a wet cloth.
Protecting the environment
Unpack the appliance and dispose of the packaging in
an environmentally friendly manner.
Operating modes
You can use this appliance in the air extraction or the
recirculation mode.
Exhaust air mode
The air that is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct used
for ventilating furnace installation areas.
If the ventilation is intended to pass through a smoke
▯
or exhaust chimney that is not in operation, the
responsible area heating inspector must give
approval.
If the ventilation passes through an external wall, use a
▯
telescope wall sleeve.
8
Surface damage due to incorrect cleaning. Clean
▯
stainless steel surfaces in the grind direction only. Do
not use any stainless steel cleaners for operator
controls.
Surface damage due to strong or abrasive cleaning
▯
agents. Never use strong and abrasive cleaning
agents.
Risk of damage from condensation back flow. Install
▯
exhaust vent at a slight downward slope away from the
appliance (1° slope).
Circulating-air mode
The air that is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
Note: To eliminate odors in circulating-air mode, you
must install an activated carbon filter. The different
options for operating the appliance in circulating-air
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available from
specialist retailers, from customer service or from the
Online Shop.The accessory numbers can be found at the
end of the instructions for use.