Installing The Airbag System; Removing The Airbag System; Training Deployment - Mammut AIRBAG TECHNOLOGY 3.0 Instrucciones De Uso

16
Protection Airbag System 3.0
g) Close the zipper on the shoulder strap first and then
close the Velcro closure again.
h) Thread the zipper pull through the loop.
E g/h)
N
07 Use a new cartridge or refill the cartridge and check
the cartridge pressure (see Section 5.1).
08 Screw in the cartridge and secure it in the cartridge
pocket (see Section 5.1).

5.3 Installing the airbag system

The Protection Airbag System 3.0 can be installed in
various compatible backpacks. Please note that the
Protection Airbag System 3.0 can be installed only in
Protection Airbag System 3.0 compatible backpacks.
01 Open the airbag pocket: open the zipper from the
center and slide the zipper pull to the right shoulder
strap.
02 Spread the airbag out flat. Remove all the air from
the airbag, if necessary (see Section 5.2).
03 Make sure the airbag has not been attached the
wrong way round.
03
04 Thread the deployment handle and airbag system
through the opening in the airbag system pocket.
05 Close the airbag system pocket.
04
06 The deployment handle must not be wound around
the airbag system.
07 Place the deployment handle in the left shoulder
strap.
DO NOT
TWIST
05
07
08 Thread the four colored airbag buckles through the
appropriate loops (from bottom to top).
08
BLUE
09 Fold the airbag and pack it as described in Section
5.2.
10 Attach the deployment handle as described in Sec-
tion 5.1.

5.4 Removing the airbag system

The Protection Airbag System 3.0 can be removed
from the backpack in just a few steps. See illustration
in Section 5.3.
01 Unscrew the cartridge.
02 Open the airbag pocket.
03 Open the airbag system pocket.
04 Loosen the four airbag buckles.
05 Loosen the deployment handle in the shoulder
strap and feed it into the main compartment.
06 Thread the deployment handle and airbag system
through the opening in the airbag system pocket.

5.5 Training deployment

Training with your avalanche airbag is necessary in or-
der to become familiar with your system and to be able
to act quickly and intuitively in an emergency. In par-
ticular, you should practice deploying your avalanche
airbag in order to realize how hard you need to pull
on the deployment handle. In order to avoid refolding
your avalanche airbag after every practice, you can
also perform a test deployment without a pressure
cartridge. The Trigger Test tool allows you to perform
this test deployment very easily. We recommend at
GREEN