Installing The Airbag System; Removing The Airbag System - Mammut AIRBAG TECHNOLOGY 3.0 Instrucciones De Uso

07
09 Use a new cartridge or refill the cartridge and check
the cartridge pressure (see Section 5.1)
10 Screw in the cartridge and secure the cartridge
pocket (see Section 5.1)

5.3 Installing the airbag system

The Removable Airbag System 3.0 can be installed in
various compatible backpacks. Please note that the
Removable Airbag System 3.0 can only be installed in
Removable Airbag System 3.0 backpacks.
01 Open the airbag pocket (open the zipper from the
center to the right)
02 Spread the airbag out flat. Remove all the air from
the airbag, if necessary (see Section 5.2).
03 Before installation, the airbag system should lie
over the gray strap (red in the illustration).
03
04 Make sure the airbag has not been attached the
wrong way round.
04
05 Thread the deployment handle and airbag system
through the hole in the airbag system pocket
06 Close the airbag system pocket
08
DO NOT
TWIST
05
07 The cable must not be wound around the airbag
system.
07
08 Place the deployment handle into the left shoulder
strap
08
09 Thread the four colored airbag buckles through the
appropriate loops (from bottom to top)
09
GREEN
10 Fold the airbag and pack it as described in Section
5.2
11 Attach the deployment handle as described in Sec-
tion 5.1

5.4 Removing the airbag system

The Removable Airbag System 3.0 can be removed
from the backpack in just a few steps (see illustration
in Section 5.3).
01 Unscrew the cartridge
02 Open the airbag pocket
03 Open the airbag system pocket
04 Loosen the four airbag buckles
05 Loosen the deployment handle in the shoulder
strap and feed it into the main compartment
User Manual
06
BLUE
13
E
N