Tabla de contenido
Idiomas disponibles
Idiomas disponibles
- English -
Inline installation
1. Open the clips (A) and remove the strainer top
casing.
2. Release the clamp (B) and take pump out of the
bottom strainer casing.
3. Pull suction adapter (D) and inlet regulator (C)
from the pump.
4. Remove screws provided for fastening the
holder (E).
5. Remove holder from the bottom strainer casing.
6. Plug the rubber feet (F) (part of the accessory
kit) in the openings provided for this purpose on
the bottom of the holder (E).
7. Place the pump back into the holder (E) and
fasten with the clamp (B).
8. Connect the suction and pressure line. The
required assembly items are included in the
accessory kit.
●
Install the unit so that it is not exposed to direct
sun radiation.
Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate
the units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
Attention! The pump must never run dry.
!
Possible consequence: The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always place the unit below water level.
!
Attention! The installed temperature monitor automatically turns the pump off, if it is overloaded. The
pump automatically switches on again once the motor has cooled down. Risk of accident!
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at [email protected]. Or visit our website at www.oase-livingwater.com
A
A
A
C
D
C
D
C
D
F
F
F
B
E
E
E
5
B
B
Tabla de contenido
