Electronic Journal; Printing Journal Data On The Way Of A Transaction; Reading And Resetting The Electronic Journal Data (Issuing Ej Report) - Sharp ER-A220 Manual De Instrucciones

ELECTRONIC JOURNAL

This function is intended to record the journal data in the electronic journal (EJ) memory instead of journal paper.
For details, consult your dealer.
Recording journal data
Your register records the journal data in REG, PGM,
X1/Z1 and X2/Z2 modes, the header information (please refer to EJ report sample shown below.) is stored in the
memory.

Printing journal data on the way of a transaction

You can print journal data of a current transaction recorded in EJ memory by pressing the
transaction.
• This function is valid when the printer type is set to receipt type on the programming, and also the
receipt ON/OFF function is set to OFF.
• Sample receipt

Reading and resetting the electronic journal data (Issuing EJ report)

You can read the journal data stored in the EJ memory in the journal format by executing following procedure in
the X1/Z1 or OP X/Z mode.
To read/reset all of the data:
700
To read the last 10 records:
710
• On the EJ memory, a maximum of 2500 lines of data can be
stored. When executing all data reading, all of the data stored
in the EJ memory will be printed. So, make sure that there are
enough paper on a paper roll. To save paper, compression
print is available. Please consult with your dealer for details.
• To stop reading or resetting the data, turn the mode switch to
"MGR" position. However, when you are resetting the data, it
will not be cleared.
• You can set a warning system to let you know the time when
the memory is almost full, and/or to lock the data entry except
issuing the EJ report when the memory is full. Please consult
with your dealer for details.
EJ report title
EJ report end title
Reading
. ≈ É
Resetting
≈ É
, X1/Z1 and X2/Z2 modes into the EJ memory. In the
• Sample EJ report
Ü
key during the
Header
information
print
35