Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PREPARE THE HOOD
1. Remove the grease filters by pulling
down in the filter latch, and pull the filter
downwards (Fig. 4); repeat for all filters.
2. Remove (2) grease filter spacers,
unscrewing (4) screws (Figure 5).
INSTALLATION
Remove the plastic protective film from all
exterior surfaces, decorative flues and
filters, prior to final installation
The hood is intended to be installed
inside a cabinet.
ATTENTION: 2 people are required for
proper installation; the unit should be
installed by a qualified operator.
For the cabinet measurements, refer to
Figure 6 and 7.
For new construction it is recommended to
install a wood support that is flush with
interior surface of wall studs (Figure 11 ).
Make sure:
a)the wood support is centered over
installation location.
b)the height of the wood support will allow
the hood to be installed within the
dimensions shown.
Notes: Minimum cabinet hood distance
above cook top must not be less than 24". A
maximum of 30" above cook top is highly
recommended for best capture of cooking
impurities. Distances over 30" are the
installer and user discretion.
FIGURE 7
Top view
(ducted hood)
7.95"
4.37"
ø6.29"
3.98"
FRONT
- 7 -
FIGURE 4
GREASE FILTERS
FIGURE 5
FIGURE 6
12.7"
from 34.5 to 34.75"
4.37"
Top view
(non-ducted hood)
FRONT
GREASE FILTER
SPACERS
13"
Tabla de contenido
