Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
3.
Handle the bits very carefully.
4.
Check the bit carefully for cracks or damage before operation. Replace cracked or
damaged bit immediately.
5.
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
operation.
6.
Hold the tool firmly with both hands.
7.
Keep hands away from rotating parts.
8.
Make sure the bit is not contacting the workpiece before the switch is turned on.
9.
Before using the tool on an actual workpiece, let it run for a while. Watch for vibration
or wobbling that could indicate improperly installed bit.
10. Be careful of the bit rotating direction and the feed direction.
11. Do not leave the tool running. Operate the tool only when hand-held.
12. Always switch off and wait for the bit to come to a complete stop before removing the
tool from workpiece.
13. Do not touch the bit immediately after operation: it may be extremely hot and could
burn your skin.
14. Always lead the power supply cord away from the tool towards the rear.
15. Never run the motor unit when it is not inserted in one of the router bases.
The motor is not designed to be handheld.
16. After changing the bits or making any adjustments, make sure the collet nut and any
other adjustment devices are securely tightened.
Loose adjustment device can unexpectedly shift, causing loss of control, loose rotating
components will be violently thrown.
17. Definitions for symbols used on this tool
V ............ volts
Hz .......... hertz
A ............ amperes
n
.......... no load speed
o
---/min ... revolutions per minute
........... alternating or direct current
6
Tabla de contenido
