Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna PP 325 E Manual De Instrucciones

Before starting

Make sure that:
• The machine is correctly connected to a suitable
power supply and correctly fused.
• The hoses have been connected to a device.

Starting

NOTICE! When starting, the switch must only be turned
to "START 5 SEC" for about 5 seconds. The switch is
then turned to "RUN". The engine may be damaged if
the switch is in the "START 5 SEC" position too long or
when operated.
The engine is started with a Y/D switch. The start takes
place in two steps to avoid overloading the fuse the
machine is connected to.
• Turn the switch to "START 5 SEC" in the direction
indicated by the lit lamp. The direction of rotation of
the engine will then be correct.
• Turn the switch to "RUN" when the engine speed is
constant after about 5 seconds.

STARTING AND STOPPING

• Open the tap to suitable water flow for the tool in
question.
If the tool does not require water, cooling water should
still flow through the radiator, and then to the closest
floor drain.

Stopping

Switch off by turning the switch to "0".

After work is completed

• Disconnect the hydraulic hoses.
• If there is a risk of freezing, the machine must be
drained of any remaining water coolant. Disconnect
incoming and outgoing water hoses and tilt the
machine forwards.
–
English 11