Ingersoll Rand ARO Manual Del Usuario página 19

1. Setup
The Setup menu features a number of options to modify the controller's general behavior (General Setup), program specific pump run modes
(Run Setup), and specify general pump behaviours (Pump Setup).
The Setup menu is password protected. To exit the password-protected menu, press "NAVIGATE TO PREVIOUS" enough times to exit the Setup
menu; press "NAVIGATE TO HOME", or leave the controller unattended. After 10 minutes of no key strokes on the keyboard the controller will
automatically exit the password protected menu. If the screen shows a pump that is running, the screen will change to the equivalent running
mode screen outside the password-protected menu. In all other cases, the controller will exit to the Home screen.
a. General Set up
47520296001_edD
On the Home screen, select "Setup" and then press ENTER.
On the "Setup" screen, press ENTER type the password: 27632, and then press ENTER again.
When the correct password is entered the Setup screen is displayed.
If a wrong password is typed, an alert message is displayed. Select "Password", press ENTER and type the correct
password.
Select "General Setup" and then ENTER.
To change the display language, select "Language" and then press ENTER.
Select the desired language and then press ENTER.
Press "NAVIGATE TO PREVIOUS" button to go back to the Setup screen.
To change the unit of measure, select "Units" and then press ENTER.
Select the desired unit of measure and then press ENTER.
If other than "Cycles" is selected, the calibration process needs to be followed. See section to 1.c.iii.
Note: The default unit of measure is cycles per minute.
To adjust the screen contrast, select "Contrast" and then press ENTER.
Use the LEFT and RIGHT keys to adjust the contrast as desired and then press ENTER.
Note: The screen contrast may vary with ambient temperature.
EN
EN-2