RIDGID R4210 Manual Del Operador página 24

Sierra ingleteadora compuesta deslizante de 254 mm (10 pulg.)
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY
TO ADJUST THE BEVEL
See Figures 28 - 29.
 Remove the bevel lock dust cover.
 Move the bevel bypass lever to the detent disengaged
position.
 Set the bevel at any angle that allows access to the 4
screws on the back of the bevel lock bracket.
 Tighten the bevel lock knob.
 Using a 4 mm hex wrench, loosen the 4 screws that hold
the bevel detent plate in place. Do not remove the screws.
 Loosen the bevel lock knob and move the bevel bypass
lever to the detent disengaged position.
 Set the bevel angle at 0°.
 Move the bevel bypass lever to the detent engaged posi-
tion.
 Check the 0° angle using a combination square.
 If adjustment is needed, use a 4 mm hex key to turn the
micro adjust screw on the front of the bevel lock bracket
to adjust the saw to the 0° bevel angle.
 Tighten the bevel lock knob.
 Tighten the 2 outermost screws that retain the bevel
detent plate.
 Loosen the bevel lock knob and set the bevel at any angle
that allows access to the 2 remaining screws on the back
of the bevel lock bracket.
 Tighten the bevel lock knob.
 Tighten the remaining 2 screws that retain the bevel de-
tent plate.
 Replace the bevel lock dust cover and tighten the screws
securely.
SCREWS
BACK OF BEVEL LOCK BRACKET
SCREWS
FRONT OF BEVEL LOCK BRACKET
MICRO ADJUST
SCREW
24 - English
BEVEL BYPASS
LEVER
BEVEL LOCK
BEVEL LOCK
DUST COVER
BEVEL DETENT
KNOB
Fig. 28
SCREWS
PLATE
Fig. 29
Tabla de contenido
loading

Tabla de contenido