Wolf Garten Robo Scooter 500 Instrucciones De Servicio Originales página 53

Message
Probable Cause/Event
Displayed
Splice wire (Con-
firm the Base Stati- • Perimeter wire cut
on beeps • Wire disconnected from the Base Station / Perimeter
continuously for Switch
cut wire)
• An unknown fault has occurred and user help is requi-
red.
Start elsewhere
• Drive wheel motors have been working under a severe
load during automatic or manual operation.
• Automatic operation is initiated while Robo Scooter
Start inside
500 is placed out of the perimeter wire lope
• Robo Scooter 500 get stuck in place with no succeed
to continue driving.
Stuck in place
• Robo Scooter 500 has difficulty to turn in place be-
cause the front wheel has fallen into hole or indention
and it caused the mower to turn in place without detec-
ting wire or bumper.
Switch off before • The user carries Robo Scooter 500 manually while the
lifting main switch button is on.
Switch off before
lifting (While Robo • Robo Scooter 500 does not detect the power from the
Scooter 500 is in base Station, there is a charging problem .
the Base Station)
• Displayed every time the batteries fuse is taken out of
Time and date
the mower (reset operation).
• The operating time set for that zone has been
Time completed
reached.
Waiting for • Robo Scooter 500 has stopped the operation, be-
signal... cause there is no signal detected.
en
Corrective/User Action
• Confirm wire is plugged in and wire leads are firmly at-
tached.
• Walk along perimeter, including islands and look for obvious
cuts or break in the wire. Repair with Robo Scooter 500 wire
splice connectors.
• In case the wire cut is not visible call your service dealer for
more information how to find the wire cut.
• Manually drive/carry the mower away from this particular
area and restart operation.
• Check to insure the mower is not stuck, allowing the drive
wheels to slip.
• Check the ground for holes or indentions, where the mower
has stopped and fill it with dirt and level off.
• Check the drive wheels are free to rotate and nothing block
them.
• Remove the mower away from this particular point and re-
start operation.
• Place the mower inside the lawn and press the 'GO' button.
• Check the ground for holes or indentions, where the mower
has stopped and fill it with dirt and level off – especially in the
area close to the perimeter, where the Robomow turns in
place.
• Confirm the area is not too sloppy and make sure to work in
dry condition.
• Check the perimeter wire is not too close to the edge – re-
move if required.
• Conform the mowing deck is not set too low.
• There is an option to drive back to the lawn in reverse before
Robo Scooter 500 perform the turn in place (contact your
service dealer for details).
• Switch off the main switch button before carrying Robo
Scooter 500.
• Check the connection of the Base Station board cables (red
and black) to the Base Station pins; confirm the screws are
tightened.
• Confirm good contact between Robo Scooter 500 and the
Base Station charging pins.
• Make sure the pins are clean and not corroded.
• Set real time clock (day and hour) and the date.
• Connect to the charger if all mowing has been completed for
the day.
• Check the power to the Base Station.
• There is electrical power interruption. There is no need to do
anything – Robo Scooter 500 will renew automatically the
operation if the power will come back within an hour from the
break; if the power will come back after more than one hour,
Robo Scooter 500 will drive back to the Base Station for
charging, but will not renew the operation and mowing.
53