Installing The Sd-20 Driver (Oms) - Edirol Canvas SD-20 Manual Del Usuario

Installing the SD-20 driver (OMS)

Use the following procedure to install the SD-20 driver.
The included SD-20 OMS driver is an add-on module for using the SD-20
with OMS. In order for you to use it, OMS must already be installed on the
hard disk from which you started up.
If you would like to learn more about OMS, refer to OMS_2.3_Mac.pdf
(online manual) in the OMS2.3.8 folder within the OMS folder of the CD-
ROM.
* Disconnect the SD-20 from the Macintosh before you perform the installation.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
3
Double-click the SD-20 USB Installer icon (found in the Driver - OMS
Driver of the CD-ROM) to start up the installer.
4
Verify the installation location, and click [Install].
fig.3-2_40
5
If a message like the following is
displayed, click [Continue].
The other currently running
applications will exit, and
installation will continue.
6
A dialog box will indicate Installation completed.
Click [Restart] to restart your Macintosh.
7
Use the USB cable to connect the SD-20 to your computer.
8
Set the SD-20's power switch to the ON position.
Getting connected and installing drivers (Macintosh)
Requires OMS 2.3.5 or
later.
OMS can be found in the
OMS2.3.8 folder within the
OMS folder of the CD-
ROM.
You will need the Adobe
Acrobat Reader in order to
view OMS_2.3_Mac.pdf.
The latest version of
Adobe Acrobat Reader can
be downloaded from the
Adobe website. http://
www.adobe.com (This
URL may change without
notice.)
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
45