Serial Connection - Edirol Canvas SD-20 Manual Del Usuario

Serial connection

The following items are required for connections and installation. Please
have the following items ready.
• SD-20
• AC adaptor
• Computer cable
• CD-ROM
1
Turn off the power of the Macintosh and all peripheral devices connected to
the Macintosh.
2
Set the computer switch of the SD-20 to Mac.
3
Use a computer cable to connect the modem port or printer port of your
Macintosh to the SD-20.
4
With the SD-20's power switch turned off, connect it to the AC adaptor.
5
Plug the AC adaptor into an AC power outlet.
6
Turn on the power of the SD-20 and your Macintosh.
Installing the SD-20 driver (OMS)
Use the following procedure to install the SD-20 driver.
The included SD-20 OMS driver is an add-on module for using the SD-20
with OMS. In order for you to use it, OMS must already be installed on the
hard disk from which you started up.
If you would like to learn more about OMS, refer to OMS_2.3_Mac.pdf
(online manual) in the OMS2.3.8 folder within the OMS folder of the CD-
ROM.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
fig.3-14_40
3
Double-click the SD-20 Serial Installer icon (found in the Driver - OMS
Driver of the CD-ROM) to start up the installer.
Getting connected and installing drivers (Macintosh)
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
Requires OMS 2.3.5 or
later.
OMS can be found in the
OMS2.3.8 folder within the
OMS folder of the CD-
ROM.
You will need the Adobe
Acrobat Reader in order to
view OMS_2.3_Mac.pdf.
The latest version of
Adobe Acrobat Reader can
be downloaded from the
Adobe website. http://
www.adobe.com (This
URL may change without
notice.)
51