Edirol Canvas SD-20 Manual Del Usuario página 20

Getting connected and installing drivers (Windows)
fig.2-4_30
10
The SetupInf dialog box will
appear.
You are now ready to install the
driver.
* Do not click [OK] at this time.
11
Connect the SD-20.
1. Set the computer switch of the
SD-20 to USB.
2. With the SD-20's power switch turned off, connect it to the AC
adaptor.
3. Plug the AC adaptor into an AC power outlet.
4. Use the USB cable to connect the SD-20 to your computer.
12
Set the SD-20's power switch to the ON position.
Near the task bar, your computer will indicate "Found New Hardware."
Please wait.
fig.2-6
13
The Found New Hardware
wizard will appear.
Make sure that the screen
indicates "EDIROL SD-20," select
"Install from a list or specific
location (Advanced)," and click
[Next].
fig.2-7
14
The screen will indicate "Please
choose your search and
installation options."
Select "Don't search. I will
choose the driver to install," and
click [Next].
20
If a message of "The
driver is already
installed" appears, you
can connect the SD-20 to
your computer and use it.
Even if you will normally
be using the SD-20 with
BUS power, please use the
AC adaptor while you are
installing the driver and
making settings.
This unit is equipped with
protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.