Assembling The Unit - Stihl SR 430 Manual De Instrucciones

English
fire; never operate your power tool if the
screen is missing, damaged or clogged.
Remember that the risk of a brush or
forest fire is greater in hot or dry
weather.
In California, it is a violation of § 4442 or
§ 4443 of the Public Resources Code to
use or operate gasoline-powered tools
on forest-covered, brush-covered or
grass-covered land unless the engine's
exhaust system is equipped with a
complying spark arrester that is
maintained in effective working order.
The owner/operator of this product is
responsible for properly maintaining the
spark arrester. Other states or
governmental entities/agencies, such as
the U.S. Forest Service, may have
similar requirements. Contact your local
fire agency or forest service for the laws
or regulations relating to fire protection
requirements.
Tighten all nuts, bolts and screws except
the carburetor adjustment screws after
each use.
For maintenance items please also refer
to the maintenance chart in this
instruction manual.
Store the power tool in a dry and high or
locked location out of reach of children.
Before storing for longer than a few
days, always empty the fuel tank. See
chapter "Storing the machine" in this
instruction manual.
Store fuel in an approved and properly
labeled safety-type canister only. Take
care when handling gasoline! For health
and safety reasons, avoid direct contact
with the skin and avoid inhaling fuel
vapor!
14

Assembling the Unit

NOTICE
Hose and throttle cable, and the
metering unit's operating cable on the
SR 450, come connected ready for use
and must not be kinked while
assembling the machine.
The combination wrench and
screwdriver are in the supplied
accessory bag.
Fitting the pleated hose on the blower
tube
1 2
Push wide hose clamp (1), marks
N
facing right, onto the blower tube
(2).
4 3 2
Push the ring seal (3) (wide lip
N
facing left) onto the stub on the
blower tube (2).
Push the pleated hose (4) over the
N
ring seal (3).
1
4
5
Push the hose clamp (1) onto the
N
pleated hose (4).
Line up the marks on the hose
N
clamp (1) and blower tube (2) – as
shown.
Secure the hose clamp (1) with the
N
screw (5) – the blower tube (2) must
still rotate.
SR 430, SR 450
2