Operation - Husqvarna 115iPT4 Manual Del Usuario

To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
To do a function check before you use
the product
1. Examine the air intake for dirt and damage. Remove
grass and leaves from the product with a brush.
2. Make sure that the product operates correctly.
3. Tighten all nuts and screws.
4. Make sure that the saw head is attached correctly.
5. Examine the saw head for damages, for example,
cracks. Replace the saw head if it is damaged.
6. Make sure that the covers are not damaged and that the covers are attached correctly.
7. Examine the guard for damages.
8. Make sure that the guard is attached correctly. Do
not operate the product without a guard.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To connect the battery to the battery
charger
Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Connect the battery to the battery charger.
707 - 003 - 04.03.2019
3. Adjust the length of the harness until the support
hook is roughly level with your right hip.

Operation

3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs (A) on the battery come on, the
battery is fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cord.
6. Remove the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries in the product.
1. Make sure that the battery is fully charged.
2. Put the battery into the battery holder of the product.
The battery must move into the holder easily, if not, it
is not installed correctly.
A
BLi
11