Stihl MS 291 C-Q Manual De Instrucciones página 39

When the engine has turned over for
the first time
4
N Move the Master Control lever (4) to
the position starting acceleration n
N Hold and start the chain saw
Once the engine is running
4
3
N Press the throttle trigger lockout and
blip the throttle trigger (3); the
Master Control lever (4) jumps to
the operating position F and the
engine begins to idle
MS 291 C-Q
4
N Pull the hand guard toward the
handlebar
The chain brake is released – the chain
saw is ready for use.
Open the throttle only when the
chain brake is off. Increased
engine speeds with the chain
brake on (saw chain is stationary)
will quickly damage the clutch and
chain brake.
At very low outside temperatures
4
N let the engine warm up briefly with
the throttle slightly open
N if necessary, configure for winter
operation, see "Winter Operation"
Switch off the engine
N Move the Master Control Lever to
the stop position 0
If the Master Control lever was moved
from the position starting
acceleration n to the stop position 0 –
afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
If the engine does not start
The Master Control lever was not
returned from the position choke shutter
closed l to starting acceleration n in
time, the engine may be flooded.
N Move the Master Control Lever to
the stop position 0
N Remove the spark plug – see
"Spark plug"
N Dry spark plug
N Crank the engine several times with
the starter – to clear the combustion
chamber
N Replace the spark plug – see
"Spark plug"
N Set the Master Control lever to
starting acceleration n – even if
the engine is cold
N
Restart the engine
English
37