Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Wire broken or falling off. Check the connec-
tion.
NO NO-LOAD VOLTAGE.
Welder getting overheated.
Switch broken. Replace the switch.
ELECTRODE HOLDER AND CABLE GETTING
HOT;"+" "-" POLAR SOCKETS BECOMING HOT
Electrode Holder's capacity is too small. Replace
it with a bigger capacity one.
Cable is of small size. Replace it with another
one in conformity with the requirement.
Bigger resistance between the electrode hold-
er and the cable. Remove the oxide skin and
tighten it.
DIAGRAMA ELÉCTRICO / ELECTRICAL WIRING
14
POWER SOURCE TRIPPING.
Resume power over a long period of time (more
than two days). Not failure. Trip caused by the
main power filter's capacity charging. Switch on
the main power source.
In the process of welding. Contact an autho-
rized service center.
OTHER
Contact an authorized service center.
Tabla de contenido
