Using The Led Light - Panasonic EY7411 Manual De Instrucciones

to be driven can be changed within
the range of the screw count val-
ues.
3. To prevent changes in the set values
due to operational errors.
● Turn the HOLD switch
to ON.
■ While setting, if no operations are
conducted for 60 or more seconds or
when the battery is removed
● Operation for the set value be­
comes invalid.
Please reset the operational values.
■ When batteries are changed while in
use
● When batteries are changed, the
count value is saved. Therefore,
the drill can be used continuously.
 Battery Low Warning Lamp
<Battery low warning lamp>
Off
(normal
operation)
Excessive (complete) discharging of
Li-ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
● The battery protection feature acti-
vates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
● If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
 Clutch Lock Cover
The clutch lock cover allows you to
lock the clutch at the selected setting.
Attaching the cover
1. Select the appropriate clutch set-
ting for the application.
ON
Flashing
(No charge)
Battery
protection
feature active
- 10 -
. Attach the clutch lock cover.
● Align the triangle mark on the
cover with the graduation selec-
tion mark on the drill and attach.
Triangle mark
Removing the cover
1. Grip the clutch lock cover with your
fingers on the  mark and the bot-
tom of the cover, then push in and
twist to remove.
● It will be difficult to remove the
clutch lock cover from the drill if
you push on the side of the cover
while pulling it off.
 Using the LED Light
Use the LED light on jobs in dark
locations such as attics to illuminate
your workspace.
CAUTION
● The LED light is intended for use as
a supplemental light source. Do not
use it as a flashlight.
Doing so may result in accident or
injury.
● Do not look at the light or shine it
directly into your eyes.
Continuous exposure to the LED
light may damage your eyes.
1. Press
and off.
● To use the light immediately after
attaching the battery pack or after
the drill has not been used for 5
minutes or more, operate the drill
briefly.
Graduation selection
mark
to toggle the light on