End Of Cycle; Auto Stand-By Option; Draining Water Out After End Of Cycle; Daily Use - Drying Only - AEG L 75480 WD Manual De Instrucciones

20 www.aeg.com
The programme or the delay start
continues.

10.13 End of cycle

When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
locked indicator
The indicator of Inicio/Pausa button goes
off.
1. Press button On/Off to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
10.14 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.

11. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.

11.1 Drying setting

WARNING!
Make sure that the water
tap is open.
1. Press On/Off for some seconds to
activate the appliance.
2. Load the laundry one item at a time.
comes on and the door
goes off.
The door lock indicator
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Inicio/Pausa button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press On/Off some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.

10.15 AUTO Stand-by option

The AUTO Stand-by option automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you press Inicio/Pausa
button.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button On/Off to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
3. Turn the programme dial to the
programme applicable for the items
to dry. The display shows the drying
indicator .
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
is on. The
goes