Abicor Binzel TCS-FP Manual De Instrucciones página 48

6 Commissioning
6.6.3 Wire cutter (DAV)
1 Cover
2 Lubricating nipple
Fig. 10 Wire cutter
1 With the free wire end, move the torch into the cutting area of the wire cutter so that the wire comes in contact with the
fixed jaws (5) and the gas nozzle is positioned directly over the cutter (4) at the required stick-out distance (wire
protrusion).
 13.1 Pneumatic Plan on page EN-28
2 Program the positions and commands as shown in the flow chart.
Once the fixed cutting plates reach their wear limit (poor cutting quality, cutting device jams, wire is no longer cut, etc.), they
must be refurbished or replaced.
 Operating instructions for wire cutter
NOTICE
• Lubricate the cutting plate with the lubricating nipple (2). This extends the service life of the cutting plate.
EN - 18
1 2
3 Counter support with pressure spring
4 Cutter
3 4
5
5 Jaws
BAL.0713.0 • 2019-02-11
TCS-FP