Craftsman 536.889252 Manual Del Usuario página 8

TOASSEMBLE THEHANDLE
1. Cut t ieholding s hift r odtolower h an-
dleand move shifter totheneutral
position.
2. Loosen, butdonotremove, the
screws, flatwashers, Iockwashers,
NOTE: M ake sure thecables a renot
caught between theupper andlower h an-
dle.
4. Raise t heupper h andle i nto operating
position.
and hex nuts in the upper holes of the NOTE: If the cables have become dis-
lower handle. See Figure 3. connected form the drive levers, reinstall
Remove the fasteners from the lower the cables as shown in Figure 4.
holes of the lower handle See
Figure 3.
Right Hand Side
Of Upper Handle_
-h
5/16" Hex Nut _
5/16" Split _
Lockwasher
//
t Loosen,
but do not
remove
/ 111/a3t2"ashe r
Figure 3
Lever
"Z" Fitting X
Control Cable Figure 4
5. install the fasteners that were re-
moved in step 3. DO NOT tighten until
all bolts are in place.
6. Tighten all handle bolts.
F-O41074L 8