How To Set The Drift Cutters
Drift cutters are used to cut a path
through snow deeper than the auger
housing.
1. Loosen the wingnuts that secure the
drift cutters to the auger housing.
See Figure 12.
2. Raise the drift cutters to the desired
height.
3.
Tighten
the wingnuts.
Wingnut
Drift Cutter
Figure 12
_" CHECKLIST
Before
you operate
your new snow throw-
er, to ensure
that you receive
the best
performance
and satisfaction
from this
quality
product,
please
review
the follow-
ing checklist:
_'
All assembly
instructions
have
been
completed.
v'
The discharge
chute
rotates
freely.
v'
No remaining
loose parts
in carton.
v'
On electric
start
models,
the unit was
shipped
with
the starter
cord
plugged
into the engine.
Before
operating,
un-
plug the starter
cord from the engine.
While
learning
how to use your snow
thrower,
pay extra
attention
to the follow-
ing important
items:
_'
Engine
oil is at proper
level. Use a high
quality
detergent
oil classified
"For Ser-
vice SG, SH, S J, SL, or higher".
_'
Make
sure
gas tank
is filled
properly
with
clean,
fresh,
unleaded
gasoline
with a minimum
of 85 octane.
_'
Become
familiar
with all controls-their
location
and function.
Operate
controls
before
starting
engine.
F-041074L
12