Craftsman 536.889252 Manual Del Usuario página 32

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

HOW TO CHECK
AND
ADJUST
THE CABLES
The cables
are adjusted
at the factory
and no adjustment
should
be neces-
sary.
If the cables
have become
stretched
or are sagging
an adjustment
will be necessary.
Whenever
belts are adjusted
or re-
placed,
the cables
will need to be ad-
justed.
To check for correct
adjustment,
un-
hook
"Z"
fitting
at clutch
lever
(see
Figure
43).
1.
Move
clutch
lever to the full forward
position
(just contacting
plastic
bumper).
Holding
cable tight, note
position
of fitting to hole in clutch
le-
ver.
"Z" Fitting
either
the auger
drive cable or the
traction
drive cable as necessary
according
to the following
instruc-
tions.
Auger Drive Cable Adjustment
1. Run the engine until the fuel tank is
empty and the engine stops.
2. Stand the snow thrower up on the
front end of the auger housing.
3. Push cable through spring to ex-
pose the threaded portion of the
cable (see Figure 44).
Square
End
Cable Spring
o
Locknut
Figure 43
The center
of the "Z" fitting should
be between
the center
and top of
the hole in the clutch
lever. Adjust
Figure 44
Hold square end of threaded portion
with pliers and adjust Iocknut in or
out until correct adjustment is
reached. Pull cable back through
spring and connect cable.
F-O41074L
32
Tabla de contenido
loading

Tabla de contenido