Important Notice - LEGRAND 430 523 Manual De Usuario

INSTALLATION WITH WALL MOUNT BRACKET
1 Make a hole whose diameter is 30~40mm on
the mounting surface to pass the wire(s) and
cable(s) through the mounting surface.
(In case of the wiring and cabling through the
mounting surface only) Then prepare the wall
mount bracket. Pull the wire(s) and cable(s)
for the system as below. Attach the wall mount
bracket to the mounting surface. (Hex Lag
#14x50)
3 Screw the dome cover to the main body and
remove the protection vinyl from the dome cover.

Important Notice

• Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
*
*
*
2 Pull the wire(s) and cable(s) for the system as
below. Wire the cable(s) to the ports. Insert the
mounting hooks into the holes on the surface of
the main body and turn the main body. Assemble
the main both with the camera mount adaptor
with the 3 screws. (Machine M5x15)
27
×
× ×