Peaq PDR261BT-B Manual De Instrucciones página 20

Size = A5
ENGLISH
LAN CONFIGURATION
If you do not have a wireless network but do have
a cabled network, you can connect the Internet
radio with a network.
1. Switch the radio off.
2. Connect an Ethernet cable to the LAN socket.
Once switched on and choose wired. The radio
will automatically be recognized as a cable
client.
3. For manual network cable setup go to the
settings (MENU) when using Internet Radio
mode and select System Settings / Internet
Settings / Manual Settings / Cable. Select
DHCP active as the standard setting.
Note
Only use shielded LAN network cable for internet
connection via LAN. If no shielded LAN network
cable is available, please purchase a shielded LAN
network cable for the internet connection via LAN.
WLAN-REGION AND WLAN-NETWORK
Select the WLAN-Region in which you are located.
The device then looks for available wireless
networks. If a wireless network is not found, the
device shows the notifications [Rescan] [Wired]
[Manual config]. Please check in this case
whether your router and WLAN are switched on.
Note
Make sure that the DHCP-server of your router
(Access Point) is activated. Otherwise, the WLAN
connection must be configured manually. The
WLAN should send out the SSID. If the SSID is not
sent out, you must configure the WLAN manually.
• Select the network from which you want to
operate Internet radio.
PUBLIC NETWORK CONNECTION
Select the appropriate WLAN-network by clicking
on the entry of the network's name. The connection
procedure takes place automatically.
Note
In the Systems settings > Setup wizard, you can
manually configure the network.
20
IM_PDR261BT-B_190923_V04_HR.indb 20
PRIVATE NETWORK CONNECTION
Select WPS connection type
If a network is protected by a WEP or WPA
encryption, the query for constructing a connection
over WPS (Wi-Fi Protected Setup) appears. If
the router of your wireless network has a WPS
function, select whether the WPS connection
should be established by entering a PIN code over
the WPS key on the router.
WPS connection using PIN entry
A WPS-PIN appears in the Internet radio display.
Enter this PIN and confirm the Internet radio with
OK. The WPS connection will then be established.
Connection using WPS key
Press the WPS key on the router and then confirm
the display on Internet radio with SELECT. The
WPS connection is then established.
CONNECTION USING THE DIRECT ENTRY OF
THE NETWORK KEY
If you do not want to establish any connection
using the WPS, select the entry, No WPS and then
enter the network key in the following dialogue.
Confirm the entry with SELECT.
COMPLETING THE WLAN CONNECTION
1. The connection begins. The device should
now establish a connection with the WLAN.
Once the connection has been established,
"Connected" appears. Confirm the display with
SELECT.
2. If the WLAN cannot be accessed (e.g. locked
for new WLAN devices) the failure notification
"Connection not successful" appears.
3. In this case, check the setting of your WLAN-
router.
Note
The entered password (WEP / WPA key) will be
saved and will not need to be entered again.
DEACTIVATE WIRELESS NETWORK PORT
1. Go to Main menu => System settings =>
Network => Keep network connected.
2. Select "No" and then press the SELECT dial to
deactivate the network connection.
23/9/19 6:04 pm