Idiomas disponibles
Idiomas disponibles
CLEANING
1. Switch off the trimmer and remove the battery.
2. Do not use aggressive detergents or solvents. Clean the machine after use with a damp cloth dipped in
mild detergent.
3. Keep battery connection free of dirt and debris, and clean with a soft and dry brush or cloth.
4. Do not spray water onto the motor and electrical components.
5. Do not use pressure washer to clean your machine.
STORAGE
1. Remove the battery pack from the trimmer before storage.
2. If the machine becomes wet in the rain during operation, the machine and the battery should be dried
before storing or charging. Remove the battery and reinsert it if the machine fails to turn on.
3. Store the trimmer and the battery in a dry and secure place that is inaccessible to children and other
unauthorized people.
Remove the cutting attachment if it will not be used for a long time.
4. Store the battery only within a temperature range between 41
not leave the battery in the car in summer time.
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
TRIMMER
Problems
Battery indicator LED
flashing
Error LED flashing
The product does not start
Trimmer runs intermittently
Excessive vibrations/ noise.
Possible Causes
Low battery voltage.
Overload.
Temperature issue.
The Throttle Trigger and the
start/stop button are pressed
at the same time.
Other problems
Debris in the battery
connectors.
Other problems
The battery is not fully
inserted to the machine.
Potential electrical issue.
Line balance issue.
Cutting attachment issue.
Machine defective.
F (5
C) and 77
F (25
C). As an example, do
o
o
o
o
Corrective Action
Charge the battery.
The cutting attachment is jammed.
Deactivate the product.
Remove the battery.
Clean the cutting attachment from
unwanted materials.
Let the product cool down.
Release Throttle Trigger. Perform the
starting sequence again.
Contact Service Agent
Clean the battery connectors with
compressed air or a soft brush.
Contact Service Agent.
Insert the battery fully.
Contact Service Agent.
Rewind the line.
Replace cutting attachment.
Contact Service Agent.
EN
15
